The DMM 18-1 compressed air through-distributor is primarily installed at points in the compressed air distribution system where, in addition to the through-distribution, the extraction of compressed air is also required. The compressed air flows through the DMM 18-1 Compressed Air Through Manifold and can be removed via the quick-action coupling.
Note:
The brass 15 mm compression fitting greatly facilitates installation with the appropriate plastic or aluminum piping from KDT. Please make sure that the compressed air pipe is inserted at the correct insertion depth, that the clamping ring is present and that the correct support sleeve has been inserted for plastic pipes!
Special features:
- Tightening torque thread plastic: 4 Nm
- Mounting hole: 4 x 4.6 mm
- Compressed air outlet with quick coupling NW 7.2 with sealing ring made of NBR(P) sealed ready for operation!
- Compressed air inlet and outlet with compression fitting 18 mm glued in with seal made of PVC for gap sealing
- Compressed air manifold VDK 338 complete with attachments (2 pcs. screw-in connectors, 1 pc. quick-connect coupling)
- Pay attention to areas subject to frost!
- Thread made of plastic
- Threaded connections are preferably intended for cylindrical threads (G)
- Screw in conical threads (R) with care and observe torque!
- Hole spacing: 46 x 36.5 mm (WxH)
- Medium compressed air, other operating temperatures and media on request!
- Nominal volume flow at 6 bar approx. 0.5 bar pressure difference
- Rear threaded connection Rp 1/2" can also be made subsequently by drilling and thread cutting.
Technical data:
- Dimension: 108x60x76 mm
- Connection: axial
- Max. operating pressure: 15 bar
- Operating temperature: -20°C to +50°C
- Flow rate: 1,200 l/min
- Diameter: 18 mm
- Color: Grey/Gold
- Coupling type: Quick coupling
- Length: 108 mm
- Material: Plastic
- Product type: Pipes
- Width across flats: 27 mm
- Connection type: Clamp connection
